An oval bathroom mirror should be roughly 60 to 80 percent of the width of your basin or vanity, with its centre at about eye level. That keeps it in proportion and stops it looking lost or crowded. Oval mirrors soften a room full of straight lines, and they suit many ordinary UK bathrooms. This guide covers size, hanging height, lit mirrors, fixing to tiles and common mistakes, so you can choose one with confidence.

The short answer

  • Size an oval mirror at about 60 to 80 percent of the basin width.
  • Hang it with the centre around 150 to 160cm from the floor, so it sits at eye level.
  • Choose portrait ovals for small bathrooms and wider ovals over a double vanity.
  • A lit mirror near the basin should be rated at least IP44, and mains wiring is a job for a qualified electrician.
  • Check the wall before you drill. Tiles, pipes and cables all change where you can fix.
Oval mirror above a white countertop basin on a light wood vanity.
Notice how the oval is narrower than the basin below it.

What size oval mirror suits your basin?

Start with the basin or vanity, not the wall. A mirror that is far wider than the unit below it looks top-heavy. One that is tiny looks like an afterthought.

A good rule for oval and round mirrors is 60 to 80 percent of the basin width. Here is what that means for common basin widths.

Basin or vanity widthOval mirror width to aim for
500mm300 to 400mm
600mm360 to 480mm
800mm480 to 640mm

Treat these as a starting point. Oval mirrors are commonly sold from around 500 by 700mm up to 700 by 900mm, so you may land slightly outside the range and still look right. Cut a piece of card to size and hold it on the wall before you buy.

How high should you hang an oval mirror?

Centre the mirror at about 150 to 160cm from the finished floor. That suits the eye level of most adults. If two people of very different heights share the bathroom, a taller portrait oval gives both of them a view of their face.

Then check the gap to the basin. Leave enough space for the tap to clear the bottom of the glass, and for a hand to move freely. If you have a countertop basin, measure from the top of the bowl, because it sits higher than a basin set into the unit. Our guide to countertop and inset basins explains why the heights differ.

Do not forget the ceiling. A tall oval hung high can leave an awkward gap above it, so look at the whole wall, not just the mirror.

Oval or rectangular mirror: which suits the room?

An oval has no corners, so it breaks up the hard lines of tiles, a boxy vanity and a straight bath panel. A rectangle gives more reflection across the full width of the wall. A 700mm round mirror reflects 700mm across, while a rectangle of the same size also catches the corners.

Choose an oval ifChoose a rectangle if
The room is full of straight lines and tilesYou want the widest view across a double vanity
You have a single basin and a narrow wallThe mirror sits between two fixed objects, such as a cabinet and a window
You like a softer, traditional or relaxed lookYou want a plain, modern look

We compare the two styles in more detail in oval mirrors vs rectangular mirrors. If your basin is also oval, read square basins vs oval basins before you pair them.

Should you choose a lit oval mirror?

A lit mirror gives even light on your face and saves fitting a separate light over the basin. Many oval mirrors now come with an LED ring or a back-lit edge.

There is one rule to know. Light fittings and illuminated mirrors must suit the zone they are fitted in. The area within 60cm of the basin taps is good practice to treat as a splash zone, and a mirror used near a basin should be rated at least IP44. Check the rating on the box, not just the description on the website.

  • Mains-powered mirrors: these need a cable to the mirror. Have a qualified electrician do the wiring, and make sure the circuit has RCD protection. In Scotland, building standards and BS 7671 apply, so the work should be certified by the electrician.
  • Battery mirrors: no wiring, but you will need to recharge or change batteries.
  • Demister pad: a heated pad behind the glass stops steam clouding it. It also needs a power supply.

If you are having a new bathroom fitted, tell us at your design appointment. We can plan the cable position before the walls are tiled, which is neater than chasing the wall afterwards.

Backlit oval mirror above a small white basin and chrome tap.
A lit mirror gives even light on the face and should be rated for the basin area.

What the fitter notices: fixing an oval mirror to a tiled wall

Most oval mirrors hang from two or more fixing points, and the wall behind a basin is usually tiled. This is where mirrors go wrong.

  • Use masking tape over the mark so the drill bit does not wander on the glaze.
  • Use a tile bit with the hammer action off, and go slowly with light pressure.
  • Push the wall plug in so it sits behind the tile face, not inside the tile. A plug inside the tile can crack it.
  • Avoid fixing into grout lines on a heavy mirror. Grout is soft and the plug can pull out.
  • Seal the screw hole with clear silicone so water cannot get behind the tile.

Check for pipes and cables before you drill. If you are not sure what is behind the wall, stop and ask. When we fit a bathroom, the mirror position is agreed at the design stage, so the right fixings go in before the wall is finished.

Oval mirrors in a small bathroom

A mirror makes a small room feel larger because it bounces light back into the space. An oval works well here because it takes up less wall than a wide rectangle and does not feel heavy.

Choose a portrait oval, taller than it is wide, so it fits above a narrow basin and still reflects your face. Put it opposite or beside a window if you can, so it catches daylight. If the room is tight, look at our small bathroom designs, and see how a wall-hung basin frees up space in wall-hung vs floor-standing sinks.

Tall oval mirror over a narrow wall-hung basin in a small bathroom.
A portrait oval takes little wall space and still shows your face.

Which oval mirror should I choose?

  • Choose a portrait oval if you have a single basin, a narrow wall or a small bathroom.
  • Choose a wide landscape oval if you have a double vanity or a long wall and want a softer shape than a rectangle.
  • Choose a lit oval if you want good light on your face, have a power point planned, and the mirror is rated at least IP44.
  • Choose a framed oval if you like a traditional look, and a frameless one if you want a plain, clean edge.
  • Choose a round mirror instead if you want an even softer shape.

Mistakes to avoid with oval bathroom mirrors

  • Buying a mirror that is too wide. It should not overhang the vanity below it.
  • Hanging it too high. A mirror hung for the look of the wall, not for eye level, can leave shorter users looking at their forehead.
  • Forgetting the tap. A tall countertop tap can touch or splash the glass if the gap is too small.
  • Ignoring the IP rating. A decorative mirror with a light that is not rated for the bathroom is not safe near the basin.
  • Drilling before checking. Pipes and cables can run behind bathroom walls, so check first.

What affects the price of an oval bathroom mirror

Plain oval mirrors cost less than lit ones. Size, the quality of the glass, a frame, a demister pad and built-in lighting all push the price up. A mirror that needs new wiring also adds the electrician's time.

If you want the mirror, basin, vanity and lighting planned as one job, we design, supply and fit the whole room. Our fully fitted bathroom packages start from £3,995, and finance is available from £22 per week, subject to status. You can see how we work in fitted bathrooms in Glasgow or fitted bathrooms in Paisley.

Questions people ask

What size oval mirror should I get for my bathroom?

Aim for about 60 to 80 percent of the width of your basin or vanity. For a 600mm basin, that means an oval roughly 360 to 480mm wide. Taller portrait ovals suit narrow walls, and wider ovals suit double vanities. Hold a card cut-out on the wall before you buy.

How high should I hang an oval bathroom mirror?

Centre it at about 150 to 160cm from the finished floor, which is eye level for most adults. Then check there is enough gap above the basin for the tap to clear the glass. With a countertop basin, measure from the top of the bowl.

Are oval bathroom mirrors in fashion?

Oval mirrors are widely sold and suit both traditional and modern rooms. They soften the straight lines of tiles and vanities. Pick one because it suits your basin and wall, rather than because of a trend.

Can I put a lit oval mirror next to the basin?

Yes, if it is rated at least IP44 and suits the zone it is fitted in. Mains-powered mirrors need a qualified electrician and RCD protection on the circuit. Battery-powered mirrors avoid the wiring, but you will need to recharge them.

Do oval mirrors make a small bathroom look bigger?

Any mirror bounces light around and helps a small room feel larger. A portrait oval works well because it fits a narrow wall and does not feel heavy. Place it where it catches daylight from a window for the best effect.

Ready to plan your bathroom?

Book a free home design appointment. We measure the room, plan the layout and give you a written quote. Fully fitted bathrooms start from £3,995, with finance from £22 per week*.

We design, supply and fit bathrooms in Glasgow Paisley East Kilbride Hamilton, and across the West of Scotland. See our fully fitted bathroom packages.

*Finance subject to status, application and affordability. Terms apply.

Keep reading